These files contain classified topo/bathy lidar data. Data are classified as 1 (valid non-ground topographic data), 2 (valid ground topographic data), and 29 (valid bathymetric data). Classes 1 and 2 are defined in accordance with the American Society for Photogrammetry and Remote Sensing (ASPRS) classification standards. These data were collected by the Coastal Zone Mapping and Imaging Lidar (CZMIL) system. CZMIL integrates a lidar sensor with simultaneous topographic and bathymetric capabilities, a digital camera and a hyperspectral imager on a single remote sensing platform for use in coastal mapping and charting activities. Native lidar data is not generally in a format accessible to most Geographic Information Systems (GIS). Specialized in-house and commercial software packages are used to process the native lidar data into 3-dimensional positions that can be imported into GIS software for visualization and further analysis. Horizontal positions, provided in decimal degrees of latitude and longitude, are referenced to the North American Datum of 1983 National Adjustment of 2011 (NAD83 PA11). Vertical positions are referenced to the (NAD83 PA11) ellipsoid and provided in meters. The 3-D position data are sub-divided into a series of LAS files, which are tiled into quarter-quads or 5km boxes. In addition to the lidar point data, Digital Elevation Models (DEMs), created from the lidar point data are also available. DEMs were created from all classes of points (1, 2, 29) at a 1 meter grid size and bare earth DEMs were created from the ground and bathymetric data classes (2, 29) at a 1 meter grid size. These products have not been reviewed by the NOAA Office for Coastal Management (OCM) and any conclusions drawn from the analysis of this information are not the responsibility of NOAA or OCM. The data are available upon request via email at: coastal.info@noaa.gov. Please provide the name of the data set and "DEM Request" in the subject line. The FTP versions of the LAZ files have GPS-derived orthometric heights. To adjust to the Local Mean Sea Level (LMSL) use the following value to correct the vertical heights: -0.601 m. This data set is an LAZ (compressed LAS) format file containing LIDAR point cloud data.